Installation of the CPA Chiptuning module

All CPA modules are easy to install. For most vehicles it takes approximately 15 minutes to install – no special tools or in depth automotive knowledge necessary. You connect the CPA module plugs into the specified locations, secure it and off you go. The number of plugs varies based on engine specifics.

Important – Before you start
Before you install your CPA module please be sure there is no residual power to the ECU. Please turn the engine off, open the hood, use your key remote to lock the vehicle and allow it to power down for approximately 10 minutes.

Upon order processing specific installation photos are provided via email.

Installation in 5 easy steps

Step 1

Remove the engine cover

Step 2

Based on the installation guide an accompanied photos that were emailed to you, locate the appropriate connectors.

Step 3

Loosen the original plug(s) and connect to the appropriate wire on the harness supplied in your CPA kit.

 

Step 4

Connect the CPA module with the matching connector to the wiring harness.

Step 5

Secure the wiring harness and the CPA module with the supplied cable ties in the engine compartment.

Note: This is a condensed form of our CPA installation manual. The engine photos are provided solely as an example. A more detailed installation manual will be included in the delivery of your CPA Chiptuning kit.